View Single Post
akram666 is Offline
akram666 is on a distinguished road
akram666's Avatar
Posts: 1
Join Date: Mar 2015
Default 03-16-2015, 02:52 AM

Turn over the slab and draw a 2 x 5 inch oval centering the holes for the volume and input jacks on the back. Using the router with the 1/2 inch cutter, route out the neck pocket 3/4 inch deep and the pickup pockets 1 inch deep. Turn over the slab and route out the 2 x 5 inch oval 1 inch deep. Using a 6 x 1/4 inch drill bit, and using the neck pocket for access, drill through the bottom of the neck pocket through both pickup pockets for the wires. Turn the slab over and drill the hole for the volume pot and the input jack so that all the wires can connect.
Reply With Quote