PDA

View Full Version : ehx metal muff broke


tidwop
03-22-2008, 08:07 AM
ok so my metal muff broke after a month im not impressed with ehx right now, i lost the reciept cant do a think about it right now, so i got a paper weight right now. it sounds like a really low overdrive with noo sustain whats so ever, if the pedal is even at the beginning of a chain, i was trying to see if i could eq my friends ds-1 it still sounded like the overdrive with no sustain. i dont know whats wrong, i dont want to spend 50 bucks trying to figure it out by asking them to try to find the problem not even fix it.

floydmoline
03-23-2008, 02:57 AM
well it could be any number of problems, battery may be dead (obvious), gain pot may be bungled, transistor may be dead, diodes may have been torched, if it's opamp based the chip might have gotten hot, or just died, is this a new problem or was it this way when you got it?

MrSandMan
03-23-2008, 11:37 AM
Floyd is good with technical stuff in pedals and etc.. as he is a pedal builder. He's probably one of the most qualified to help.

In my experience, the EH Muff series are built like tanks. So it's surprises me that it broke. Sounds like a factory defect...

floydmoline
03-24-2008, 08:06 AM
more than likely if it's the same volume as before just not as distorted it's a goofy transistor, hard to say without hearing the problem personally, and or seeing the electronics

tidwop
04-04-2008, 10:12 PM
well it was never like that, but i found that it went over the top all the time it was either, overdrive or over the top distortion which appearntly shouldnt ever happen with that pedal, there should be control of some sort :P i might just get a guyatone metal monster instead, its a bit more tighter and also i found the metal muff is a bit more british sounding than the monster.